In nearly all situations, most people spend quite a bit of money purchasing their forklift. Hence, it is very important to take proper care of it in order to protect your investment well into the long run. It is a good idea to know the procedures that are undertaken in maintaining and taking care of this machine.
Amongst the best ways to tell how good the engine is performing is by starting the forklift up and listening carefully to see how it runs. Like for instance, if there are any misses or knocks, the equipment is defective and this should raise several concerns. Furthermore listen closely for any squealing sounds which come from the belts as these noises would provide you with a lot of information.
Some of the main parts needing attention during maintenance consist of the horn, safety warning devices, gauges, the overhead guard and the lights. Any burnt out light bulbs or faulty components should be replaced as soon as they are noticed. It is also vital to inspect the wiring.
The battery compartment terminals should be cleaned when the above components have been checked carefully. If the terminals are not clean, be sure to clean them well. Every battery cell should be inspected in order to ensure the fill level is topped up to the regulated amount.
The next step is to drain all of the oil out of the equipment and then change the filters. The hydraulic filter, the transmission filter and the fuel filters need to be replaced on a regular basis. Before fitting them, be sure to write the date on the new filters by using a permanent marker in order to keep track.
After the oil change is done and the filters have been replaced, a visual inspection of the drive axle needs to be performed. If there is a grease fitting on the axle make sure to apply some grease. Inspect the belts on the engine for any cracks or frays. If you find any, fix the problem accordingly. Afterwards, inspect each and every other part of the machinery like the wheels. If any kind of fault or issue is detected, be sure to address it immediately in order to make sure the equipment is running at its safest and optimum levels.